エアブラシレス 超簡単エングレービング塗装 HGUCシナンジュ 制作 #01 Tutorial: Reverse Wash Technique Without using Air brush


Hello everyone, I’m nao. Thanks for watching my channel.
This time, I would like to paint SINANJU’s engraving This time use glossy gold. And I’ll paint without using an airbrush. Quite a lot of engraving. Ok let’s get started First of all gate processing.
This part comes out in the side part. And a parting line appears here. So shave it. Shield. huge sink came out. Usually erase this by file. But this is curved surface, so using knife then use sponge file. After surface treatment, wash with detergent. When parts dry, apply primer. I usually using airbrush, but this time I use spray can. Using spray can need technic. Try avoid spray parts beginning of blowing and ending. Scratches disappeared with primer. Next, paint gloss black as base color Paint to shiny I’ll use this tool for painting later. It is the same product as Easy Painter. Easy Painter is sold only as a set.
But “air touch”, you can purchase only the cap. if you have couple of this. it’s handy. General air cans can be used, but the pressure is a little strong It may be better to use a small air can together. I’m using Star Bright Gold this time, but if you have a favorite color with a color spray, you can use it. put tape for safety. First time using “air touch”. So. paint parts after painting the test piece. After gold is dry. Coating parts with clear Usually metallic color surface is quite rough, so coat with clear color and make the surface flat After gold, paint by enamel black Not going to paint anything after this black.
So choose the condition of gloss here. Enamel paint is more difficult to put color than lacquer. Do not try to think put color at once.
Painted in a couple of times After enamel black dries, wipe it off I got two kind. one is Official zippo lighter fluid. onother one is from 1$ shop. First, I’ll try zippo lighter fluid. This parts is easy to wipe OK, next is 1$ lighter fluid. It’s smell like petrol. It’s wipe cleanly even with 1$ lighter fluid. I think not much different result between zippo lighter fluid and 1$ lighter fluid. This parts, may be a bit difficult to wipe. While looking at the manual art, wipe off It’s looks like hard to wipe.
In that case, start from easy part. Using masking tape for cover and guide. Slide the swab along the tape Mark of NEO ZEON, it’s very simple to wipe. Next is, Shield Perhaps this part is the most hard to wipe,
but first, using masking tape as a guide and wipe it off Next, I’d like to wipe the curve… I’ll use a sticker. Not stick it on the engraving Little off the engraving. Maybe this is easy way. Many curves. put sticker on. Lightly push it with a cotton swab Then wipe along the seal with the thin cotton swabs I’ll paint other parts and bring it to completion. Shield is done. In case of painting using can spray or air touch,
Can not adjust the pressure of air or the amount of paint.so Operation may be more difficult than airbrush, but since it can be painted so far with a little investment even if you dont use air blush. How was the engraving paint using reverse wash technique? Thanks for watching. and see you on next video. bye for now

Leave a Reply

Your email address will not be published. Required fields are marked *