ガンプラ 全塗装 HGUCシナンジュ・スタイン ナラティブ Ver. 制作 #02 加工・塗り分け Tutorial:How to build & paint SINANJU STEIN
Hello everyone, this is nao Thanks for watching my channel Painted engraving in the previous movie of Sinangju Stein, and this time Processing parts and paint. Cut parts for easy to paint and build. Since the dividing line is not linear, it hard to cut, but use the tools carefully and proceed The gap made by dividing is filled with plastic plate. This time I used of 0.3 mm. Continue working while checking the part’s fit. Cut unnecessary part for Slide in from the bottom Cut barrel in the middle OK, rifle is done. Calf thruster If this is moved, the joint of the knee will float In order to avoid this, cut a part of the part Cut about 1 mm, but be careful as you can see the inside poly cap if it cuts too much. The thrusters part of the knee. Cut the side at the invisible position from the outside, attach it to the other side and erase the joint line. While checking the positions of gate traces and parting lines Do surface treatment. Going to make inside of waist front armor. Trace the shape by placing the parts on the grid paper. Next, draw a linear shape with reference to the traced line Based on MG Sina Nanjystein’s parts design. After drafting on plain paper, draw with illustrator. Then, Output with silhouette cameo Cutting out extra parts Before put on this, Use epoxy putty and make it flat back side. When the parts flatten, Check the position etc. Processing of the parts is done. Wash parts after surface treatment is done. After parts dries, prime all of parts. Once the primer dries, start painting There is different images.
One is animation art and the other one is design artwork by HAJIME KATOKI. I used the color of the frame toned light brown a little. Using Steel White of Gaia Notes for the main color. The navy blue is mixed white with finisher’s super deep blue. Uses three colors for panel line. Joint part of the shoulder needs Paint dividely. The arm thrusters.
paint in enamel dark gray. You can wipe off the overflowing areas. Nozzle parts of waist side armor. After painting the whole with white, it masks only the nozzle and it paints with the frame color separately. Shield.
paint only the side of the slender part with white. Mask the border of the lower part of the side after painting the main color. Next, paint white on the side Once the white is dry, then mask the side Finally, paint the main color,
Then paint is completed. If you add panel line in the boundary part, the borderline will be inconspicuous,
so put it in Make a masking and paint the rifle. Paint the enamel’s dark gray on the duct part of the waist rear armor. Jaws of face parts, Paint with the same color as the frame. When lacquer is painted on top of the lacquer with a brush, Possibility that the lower lacquer will melt out This time, make the same color as frame color tones with enamel. OK, Done painting work. Next is decal. I use 1/144 unicorn Gundam’s decal. After decal work, paint Matte clear color for top coating. Once the top coat has dried, then will do the assembly work. Peel off the paint on the joint parts. To avoid breakage. OK, Sinanju Stein has been completed Let’s watch the gallery together. and finally gift information. how was this time? Check the overview column, for Application method of Sinanju Stein.
please check notes and please apply. Thanks for watching and see you soon. bye for now.