CARA MUDAH MENGGUNAKAN DAN CARA SETTING SPRAY GUN #TrimbellTeknik


Assalamualaikum wr wb Meet again with the channel trimbell teknik A channel that discusses everyday light techniques On this occasion I will discuss how to easily use a spray gun in painting What are the functions of each setting Top settings, middle settings, and bottom settings OK, for the first setting, which is the top setting Its function is to adjust the width of the narrowness of the spray paint If it is tightened it gets narrower, so if it gets loosened it will get wider Well, this is noticeable right? That’s the way it works, when tightly tightened, when loosened it widens OK go to the second setting, which is the middle setting This function regulates how much the amount of paint that comes out If you tighten it out a bit, well, if it’s loosened it widens Look at this The point is this middle setting, if you tighten the paint that comes out a bit, if you loosen the paint that comes out a lot Continue the third setting, which is the bottom setting The lower setting is a wind suit, serves to regulate the size of the spraygun working pressure. If it is tightened the pressure will decrease, well, if it is relaxed the pressure will increase The point is that if we tighten the wind, it will be small, if the wind is loosened it will get bigger That is the function of the down settings or wind settings Next, the last suit, which is the butterfly suit, I call it Its function is to adjust the direction of the spray, If the butterfly is horizontal (horizontal) like this the direction of the shot will be upright (vertical) Now if the butterflies are upright (vertical) like this the direction of the spray will be horizontal (horizontal) So the opposite Okay, let’s just practice it so we don’t get confused Look at the spray Widened but upright Now we go back, we point the butterflies upright (vertical) This must see it from above to be seen Now look at this, widening but horizontally (horizontally) We rotate this as needed, adjusted to the workpiece, Because there are workpieces that need horizontal width, there are those that need upright width Okay that’s a little tips from me, Don’t forget to subscribe to this channel so that it grows Thank you for watching Wassalamualaikum wr. wb

4 comments

  • Dymaz JfrogzPo041

    Tipe/seri spray nya yg apa itu boss

    Reply
  • Agoes Agus

    Perbanyakin tutorial penggunaan alat dan fungsi masing masing bagianya mas…
    Smoga chanelnya smakin brkembang…

    Reply
  • Hakam N.I

    Mak pes pes pes enggak keluar🤣

    Reply
  • #keccuu #1.3

    Request tutorial pengecatan yg baik dan benar mas broo…ditunggu secepatnyaa gx pake lama

    Reply
  • Fajar rizky

    Bang mau nanya ni
    tempat setelan untuk menyetel daya sebar cat dan tempat setelan untuk angin apa perlu atau egak untuk dibongkar dan dicuci setelah selesai kerja ya bg, apa cuman setelan jarum yang untuk keluar cat aja yg wajib kita cuci setelah selesai kerja
    mohon penjelasannya bang🙏🏼🙏🏼

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *